Micro Electromagnetic Flow Meter Introduction

Application
Micro flow electromagnetic flow meter AMag Mini adopts the latest integrated circuit, signal processing technology and
The sensor is designed by manufacturing process, and is specially used for micro flow measurement of ultra small caliber.
It can be used in chemical industry, food, medical treatment, environmental protection and many other fields.
Features of micro electromagnetic flow meter:
Compact design and low cost micro flow electromagnetic flow meter;
Suitable for liquid with conductivity of 10uS/cm or above;
Easy to install and maintenance free;
The minimum flow can be as low as 5L/h;
Optional integrated temperature sensor is provided to display the medium temperature;
Counter with two-way measurement and independent counting;
Intelligent ATC detection and judgment;
PEEK lining and optional EPDM seals can be provided for sanitary measurement;
No moving parts or mechanical wear;
Threaded connection, easy to install and disassemble;
It is easy to operate and can provide various outputs;
DC24V power supply, with or without display screen.
Technical parameters are as follows:
1. Applicable diameter: DN3-DN20
2. Electrode material: 316L, HB, HC, Ti
3. Lining material: PEEK
4. Medium conductivity: more than 10us/cm, softened water more than 20us/cm
5. Velocity range: 0.3m/s-10m/s
6. Ambient temperature: - 10-60 ℃
7. Measuring temperature: - 20-100 ℃
8. Pressure: 0.6-1.6MPa
9. Protection grade: IP65, IP67 (blind meter)
10. Shell material: cast aluminum+stainless steel
11. Connection method: thread 1/2, G3/4, NPT1/2
12. Output signal: 4-20mA, pulse/frequency, RS485
13. Power supply: DC24V
14. Current power consumption: lobule 150MA
15. Boundary dimension: 150X100X70mm
Special precautions for mini flow meter installation
During horizontal installation: the display screen should be upward and parallel to the horizontal plane, so as to ensure that the signal electrode is in the same water
On the plane. For horizontal installation, the display screen should not be installed perpendicular to the horizontal plane, so that the two signal electrodes are one on the other
When there are bubbles in the pipe, the measurement will be seriously affected.
During vertical installation: the direction of flow direction shall be vertically upward, and the direction of water flow shall also be vertically upward, instead of vertically downward.